Litter-Robot 4

Over 95% of cats acclimate to Litter-Robot*, and most begin using it within a few days to a week. (*Based on stated reasons for customer returns of Litter-Robot 4 and 3 over a one-year period). It's natural for some cats to be initially uncertain or wary of new objects in their territory. Litter-Robot 4 is designed to be as cat-friendly as possible, featuring QuietSift® technology that minimises noise during the cleaning cycle. The cleaning cycle won’t begin until minutes after your cat has exited the automatic litter tray, and you can extend the delay up to 30 minutes for skittish cats.

To ease the transition, place Litter-Robot where the old litter tray was and, for a short time, keep both nearby. Mixing a cup of used litter into the clean litter in the Litter-Robot helps provide a familiar scent. You can also leave Litter-Robot turned off until your cat has tried it. With these steps—and a little patience—most cats adapt quickly, especially if they’re already used to a covered litter tray. Learn more about acclimating your cat.

Litter-Robot 4 is suitable for cats that weigh 1.36-11.33 kg, including large breeds like Maine Coons or Norwegian Forest cats, making it one of the best litter trays for large cats. With an entryway width of 40 cm and an interior height of 41.9 cm, almost any domestic cat can fit comfortably inside the globe.

Yes. Kittens that weigh at least 1.36 kg can safely use Litter-Robot 4 in automatic mode. The unit uses laser and weight sensor technology to detect when your cat enters and exits the globe, which then triggers the countdown timer and cleaning cycle.

For kittens under 1.36 kg, we recommend using your Litter-Robot in "semi-automatic" mode to keep your kitten safe and relieve you from litter tray scooping. For "semi-automatic" mode, leave Litter-Robot powered off or unplugged. When you see your kitten has used it, wait about 7 minutes for the waste to clump, then power it on. Litter-Robot will automatically perform a clean cycle. Afterward, power it off again. Continue this supervised, semi-automatic mode until your kittens have reached 1.36 kg and can reliably activate the weight sensors.

Because waste is promptly removed and contained in the base, typical litter tray odours will be significantly reduced with Litter-Robot. Litter-Robot 4 features a sealed waste drawer and Carbon Filter to reduce odours. You can opt to combine the Carbon Filter with OdorTrap Packs to eliminate litter tray odours through natural chemistry. We also recommend using an unscented, all-natural litter to help with odour control.

With Litter-Robot 4, you’ll have access to a 7-day look at your cats’ visits and individual cat weights.

Replace the Waste Drawer Liner whenever you need to empty the waste drawer. How often you empty the waste drawer depends on the number and size of your cats. You may only need to empty the Litter-Robot 4 waste drawer as low as once every 8 days. For optimal odour absorption, we recommend replacing the Carbon Filter and OdorTrap® Packs every 2-4 weeks, but replacement frequency is up to you and your cats' usage patterns.

The best litter for Litter-Robot is clumping clay litter. We recommend a high-quality, standard-weight, clay-based clumping litter. Some silica gel litter beads and crystals can also be used with Litter-Robot, as long as they pass through the screen. However, translucent or white-coloured litter (most often seen in crystal litter) may impact the litter level and Drawer Full Indicator (DFI) accuracy in Litter-Robot 4 and are therefore not recommended. Alternative, plant-based litters typically do not work with Litter-Robot as these may not be filtered properly through the sifting system. Litters that do not work in Litter-Robot are the strictly absorbent, non-clumping or loose-clumping litters, newspaper-based litters, and absorbent wood pellet litter.

Yes. However, SmartScale® technology to record cat weight is most accurate on a firm surface, not carpeting. If you plan to use Litter-Robot 4 on carpet that's 3mm+ thick or on uneven flooring, you can improve the accuracy of SmartScale® weight readings by purchasing our specially designed Carpet Tray that sits between the unit and the floor. The Carpet Tray is not required for Litter-Robot 4 to function.

Visit our Getting Started page to view our online setup guide (including tips to acclimate your cat), the user manual, and accessory installation guides.

Buy with confidence knowing that your investment is backed by our 90-day in-home trial. If you or your pet are not satisfied with your robot appliance, simply return it for a refund of the purchase price. You only have to pay return shipping. If you have purchased your robot appliance through a source other than Whisker.com or Litter-Robot.com, you must coordinate the return with that source and according to their product return policy. Visit our Returns page for more information.

WhiskerCare™ is a comprehensive protection plan that covers your Litter-Robot from top to bottom for 2 years at no cost. A 4-year extended plan is included with most bundles, or you can purchase an extended plan. Our hassle-free plan covers accidental damage, power surges, mechanical and electrical breakdowns, and software support. You’ll have access to our dedicated customer experience specialists, software experts, and US-based service and repair team. During your warranty period, we will resolve robot issues at no charge, including free shipping both ways. There are never deductibles or hidden fees.

Visit our Litter-Robot 4 LitterHopper page to view frequently asked questions.

Litter-Robot 4 orders typically ship within 1-3 business days. It ships from Birmingham, England.

Whisker phone and chat support are available Mon-Fri: 2PM-2AM GMT and Sat-Sun: 2PM-10PM GMT at whiskersupport.com, or submit a ticket anytime. We have dedicated customer experience agents for support in English, French, German, Italian, and Spanish. We also provide chat support in Korean.

Complies with FDA performance standards for laser products except for conformance with IEC 60825-1 Ed. 3., as described in Laser Notice No. 56, dated May 8, 2019. CLASS 1 LASER PRODUCT. Patents - https://www.WhiskerIP.com | whisker.com