The store will not work correctly in the case when cookies are disabled.
Waste Drawer Liners
Cleaning Litter-Robot is as easy as taking out the trash with custom-fit waste drawer liners.
- Made specifically for Litter-Robot
- Easy to install and replace
- Compatible with any model
- 23.5" x 29"
- 9-11 gallons usable capacity
- Liner construction: 69.75% linear low-density polyethylene, 25% high-density polyethylene, 1.25% biodegradable additive, 2% slip additive, 2% anti-block additive.
How do you install the waste drawer liner in Litter-Robot 3?
It’s easy! Open a new waste drawer liner and roll down the edges about four times. Start at the back of the waste drawer and push the rolled edge of the bag into each of the four tabs, keeping the bag taut as you work forward. Make sure the bag is taut across the back and sides, then pull the slack forward toward the carbon filter. Tip: Make sure the bag does not come up past the top of the sides of the waste drawer. You want to make sure the bag sits below the edges, so it cannot be seen by the Drawer Full Indicator lenses and potentially report a false flashing blue Drawer Full Indicator light on the control panel.
How do you install the waste drawer liner in Litter-Robot 4?
Simply open a new waste drawer liner and wrap the edges over the rim of the waste drawer. Push the remainder of the bag into the bottom of the waste drawer and then slide the waste drawer closed. Press the Reset button to zero the weight sensors. Download the installation guide.
How often do I need to replace the Litter-Robot waste drawer liner?Whenever you need to empty the waste drawer. That'll depend on the number and size of your cats. For two average-sized cats, twice per week is typical. For a single cat, once per week should be fine.
Do the liners work with any Litter-Robot model?
Yes! The liners fit perfectly in the waste drawer of any Litter-Robot 4, Litter-Robot 3 (with or without Connect), or Litter-Robot 2.