Litter-Robot 3: Yellow and Blue Light (8-Hour Sleep Mode)

This mode allows you to deactivate the Cat Sensor for 8 hours so the unit will not cycle automatically. Sleep Mode is useful for units located in bedrooms or areas where you may not want the unit to cycle for a period of 8 hours.

The 8-hour period is repeated every 24 hours; the start is determined by the time the mode is initially set.

To enter Sleep Mode, at the desired time, press and hold the Cycle button until the yellow light turns on (in addition to the blue standby light). Both the yellow and blue lights will be on during the next 8 hours, indicating the unit is in 8-Hour Sleep Mode.

When the 8-hour period expires, the unit will run a Clean cycle. Once the Globe has returned to the Home position, only the blue light will be on. When the 8-hour sleep period begins again automatically, both the yellow and blue lights will be on again.

If Sleep Mode is enabled and both the blue and yellow lights are on indicating Sleep Mode is active, press and hold the Cycle button until the yellow light turns off to exit Sleep Mode. If Sleep Mode is enabled and only the blue light is on because you are not within the 8-hour sleep period, press and hold the Cycle button to exit Sleep Mode; the yellow light will flash for a few seconds then turn off.

Need technical support?

Our Troubleshooting Wizard will solve most issues and is the fastest way to get help.

Troubleshooting Wizard